PixHawk 2.1 Cube Black Standard Set with Standard Carrier Board
by Cubepilot-Proficnc

ATTENTION:

This combo has been discontinued and replaced with 

PixHawk 2.1 Cube Orange Standard Set ADS-B (Cube and Carrier)

The cube black is still available separately here, but the original carrier board is no longer available.

Pixhawk 2.1 Key Features

• Built-in IMU Heating system, allowing flights at extreme temperature (below freezing)
• Robust DF17 Interface connectors give enhanced drop and shock resistence
• Airframes: VTOL, Plane, Multicopter, Traditional Heli, Rover, Boat, Sub, General Robotics

Get Started on your road to Autonomy! This Kit contains the following items

The Cube.... the brains behind the operation.
A standard carrier board (not compatible with Intel Edison Chip).
1 Power Brick (two power bricks can be used for redundant power.)
Cable set that allows you to connect to your old Telemetry module, GPS, and sensors

Detailed includes(Cables for accessories are JST to DF13 cables which are compatible with old Pixhawk accessories, such as Telemetry, Power Brick or GPS):

• PIXHAWK2.1 Cube * 1
• PIXHAWK2.1 Carrier * 1
• POWER Brick Mini * 1
• SD Card(inserted in Cube) * 1
• TELEM Cable * 2
• POWER Cable * 1
• I2C Cable * 1
• BUZZER Cable * 1
• MICRO USB Cable * 1
• GPS1 Cable(with saftey switch) * 1
• GPS2 Cable * 1
• I2C Splitter * 1
• Mounting Screws(M2.5*8) * 4
• 3M Double Sided Foam Tape
• To take full advantage of the Pixhawk 2.1, Please add the new GPS with built in Safety switch.

Optional Accessories

• Pixhawk II - Here 2 GNSS (M8N) GPS Unit
• ProfiCNC Here+ RTK GNSS Set
• Pixhawk II - Air Speed Sensor with Pitot Tube
• Pixhawk II - 90A Current Sensor

Downloads